Whitefinish
24 July 2010, 21:48
Ik wil graag mijn pipercross filter schoonmaken (van een viperkit)
Nu heb ik dit gevonden op het internet:
The cleaning process:
1.Remove excess dirt by gently brushing the filter
2.Apply cleaning additive liberally. Massage in with soft brush, allow to soak in for around 5 minutes
3.Flush the filter out with warm water from the clean side of the foam to the dirty side.
Allow the filter to dry naturally (do not apply any heat to the filter!)
4.Lightly apply dirt retention additive on the dirty (black) side of the foam.
Steps 2-4 may need to be repeated until the filter is clean. Do not over oil the foam as this will impair performance.
Alleen het probleem is dat ik alleen het spuitbusje van stap 4 heb.
Wat kan ik gebruiken om het element schoon te maken? (en wat absoluut niet?)
Nu heb ik dit gevonden op het internet:
The cleaning process:
1.Remove excess dirt by gently brushing the filter
2.Apply cleaning additive liberally. Massage in with soft brush, allow to soak in for around 5 minutes
3.Flush the filter out with warm water from the clean side of the foam to the dirty side.
Allow the filter to dry naturally (do not apply any heat to the filter!)
4.Lightly apply dirt retention additive on the dirty (black) side of the foam.
Steps 2-4 may need to be repeated until the filter is clean. Do not over oil the foam as this will impair performance.
Alleen het probleem is dat ik alleen het spuitbusje van stap 4 heb.
Wat kan ik gebruiken om het element schoon te maken? (en wat absoluut niet?)